Formlabs Fuse 1 Generation RTD Temperature Sensor

Formlabs Fuse 1 Generation RTD Temperature Sensor

RTD temperature sensor for Formlabs Fuse 1+ 30W — is an original thermosensitive element for measuring planned indicators in the SLS printer of the Formlabs Fuse 1 series. The part is placed near air heaters and powder channels for monitoring the thermal state of the working area. The obtained values are sent to a paid controller, which allows maintaining stable conditions for melting the material.

Features

• Precise monitoring. The sensor instantly tracks minimal temperature fluctuations in the internal chamber.
• Prevention of emergency stops. Constant data transmission protects thermal blocks from critical loads and overheating.
• Full compliance with factory standards. Connectors and conductor length are designed for the standard mounting locations of the device.

When replacement is needed

The component is installed during technical maintenance or repair of Fuse 1 and Fuse 1+ 30W printers. Replacement is needed when wires, insulation are damaged, or errors Error 258, Error 261, and Error 374 appear. A new sensor restores temperature control and helps avoid deformation of parts during 3D printing.

Tips for replacement

• Wait at least 6 hours after work is completed for the work area to fully cool down.
• Be sure to disconnect the power cable from the network before removing the protective shields of the case.
• Wear an antistatic bracelet to protect control boards from static discharge.
• Route the cable through special grommets without tension and sharp bends.

Purchase the original RTD temperature sensor for Formlabs Fuse 1+ 30W to restore stable maintenance of the thermal regime. Our specialists will help select compatible parts and organize fast delivery across Ukraine.